1990 Johnson Evinrude "ES" Colt/Junior thru 8 Service Manual, P/N 507870, Page 170Get this manual
Assembly
INote Proceed
Evinrude Outboard Lubricant
slowlyMake no forced assemblies unless pressing operation is called for All internal components must be perfectly clean and lightly coated with Johnson or
INotel Use new gaskets, seals, and O-rings during assembly1If removed, install wrist pin bearing using OMC Bearing Installer and Remover PI 327645
r:J1l1 When installing wrist pin bearing the oil hole must Note
line up with the hole in rod end
r:J2l 131 2Using OMC Cone PI 333142 and Driver PI 333141, install one snap ring in groove of pistonWhen
installed, gap of the ring should be positioned opposite groove in the piston
i dling pistons that have been heated.0 0
'" To avoid personal injury, use insulated gloves when han0 0
14Heat the piston to 200 F- 400 F(93 C- 204 CUsing OMC Piston Cradle PI 326573 and OMC Pressing Pin PIN 333141oil and start the wrist pin into the piston opposite the