1990 Johnson Evinrude "ES" Colt/Junior thru 8 Service Manual, P/N 507870, Page 126Get this manual
Inst allation
181 1If flywheel key has been removed, reassemble to crankshaft with outer edge parallel to crankshaft centerline
181 f5l 2If removed, install magneto cam drive pin CD
in crankshaftApply OMC Nut Lock to the cam drive pin before installingInstall cam making certain that side marked "TOP" is up
3Apply light coating of OMC Moly Lube to the inside diameter of the armature plate liner
Install washer and liner on crankcaseCurved side of Imer tab must face crankcase
the liner tab in slot in armature plate hubMake sure that throttle cam follower is not caught under throttle control camInsert screw and tighten just enough to hold armature plate i,n selected position yet allow it to be turned without excessive effortConnect ground wire to exhaust coverBreaker Point Adjustment
f31 5Place the armature plate in position over the liner with