1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 321Get this manual
Q)CD 1431
(from engine end) through wire clamp until wire is flush in(0,8 mm) with end of casing guide
1431 Push core wire CD
Turn set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turn This kinks and locates core wire
1451 rotate cable forward untilof control.cap can be inserted into Grease trunnion pocket Lift throttle cable and trunnion
trunnion pocket of control Position throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screwCOB5635
8The throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of housing half until it contacts the stop CD