1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 320Get this manual
OMC Long Life CablesInstallation OMC Cable Adapter Kit, PI 173600, must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control and pull two halves apart2Place housing half and cover half on flat surfaceApply OMC Triple-Guard grease to all points shown in figuresBe sure to grease the three cover screw threaded holes
1381 3Lu bricate outside of brass sleeves at control end of both
remote control cables with OMC Triple-Guard grease
1 4Place trunnion caps over cable trunnion and slide
39 casing guides over cable sleeves
1401 5Using a
332 inhex wrench, start the set screws into each end of both control end wire clamps
trolMake certain fast idle lever is completely downMove throttle lever arm from behind separator plate to expose hole in lever armIt is not necessary to remove separator plate to install control cablePlace casing guide between halves of throttle lever arm and position guide as shownGrease outside diameter of wire clamp and insert clamp through throttle lever armand cable casing guide