1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 244Get this manual
1301 8Install the pinion bearings using the following components PIN 326582 Rod PIN 326583 Plate PIN 326577 Removerllnstaller 14-20 12 inScrew 14-20 114 inScrew inFlat Washer PIN 330067 Spacer, Short PIN 330068 Spacer, Long
of OMC Universal Pinion Bearing Remover and Installer PIN 391257 and two tool spacers:
Assemble the tools using short spacer PIN 330067 to install the lower pinion bearingPress against the bearing's lettered side until washer contacts short spacer Assemble the tools using long spacer PIN 330068 to install the upper pinion bearingPress against the bearing's lettered side until washer contacts long spacer
1301 rJ111321 9
To ensure accurate bearing location, washer be flat and screw must be tight
Oil and install new driveshaft bearing Q) in the bearing sleeve using OMC Bearing Installer PIN 322923Press against the lettered side of the bearing until the tool is seated on the bearing sleeveUsing the same tool attached to OMC Plate PIN 318122, press the bearing sleeve assembly into the gearcase until the plate contacts the gearcasePress against the lettered side of the bearing when installing it into the gearcase