1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 233Get this manual
1301 Using OMC Bearing Installer PI 319931 and an arbor press, install the driveshaft bearing into the bearing sleeve with the lettered side against the tool1J1l Using OMC Bearing Installer PI 319931 oil and install the bearing sleeve with the bearing into the gearcase with the lettered side of the bearing against the tool
13211331 9Using OMC Seal Installer PI 326554, install two new driveshaft seals back to back as follows:
Apply GMC Gasket Sealing Compound to the metal casing of the seals before installing Install the inner seal Q) with lip of the seal facing toward the gearcaseInstall the outer seal with lip of the seal facing away from the gearcase Apply OMC Triple-Guard grease to the seal lips after installing-'
10Coat the shift rod O-ring with GMC Triple-Guard grease and install in shift rod bushing 1341 11 Place new washer CD and bushing on OMC Shift Rod Bushing Installer PI 304515 Apply GMC Gasket Sealing Compound to the outside diameter of the shift rod bushing Using mallet, drive the bushing into the gearcase12Oil and place the fcrward bearing cone and roller assembly in the forward bearing cup 1351 13To install the forward gear and the shifter lever and yoke assembly, begin by threading OMC Yoke Locator PI 319991 through the shift rod bushing and threading it into the shifter yoke Then wh ile pulling on the yoke locator, guide the assembly into the gearcase The forward gear should come to rest against the forward bearingand the shift lever should be located in the slot at the bottom of the gearcase