1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 141Get this manual
Cleaning
INote Before
inspecting or assembling powerhead, all internal components must be perfectly clean and free of contaminants1Remove any carbon accumulation from exhaust port areas
2Remove any carbon accumulation from cylinder head combustion chambers3If cylinder walls are glazed from extended use, use medium grit hone to resurface walls Use slow RPM to achieve strong "crosshatch" pattern for best oil retention and ring sealingTo avoid piston or cylinder block damage, restore th, chamfer to all port edges using ball hone or other suitable tool
J:To avoid personal injury, wear eye protection and rubber
gloves when using OMC Gel Seal and Gasket Remover
Use OMC Gel Seal and Gasket Remover to remove all traces of gaskets, adhesives, and Gel-Seal II from the cylinder block and crankcase 5Carefully remove any carbon accumulation from the tops and ri ng grooves of the pistonsA ring groove cleaning tool can be made by breaking an old ring and grinding an angle on its endDo not damage ring grooves while cleaning6Thoroughly wash entire cylinder block and crankcase with warm, soapy water to remove all traces of contaminants