1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 115Get this manual
Ignition Component Replacement twist and remove all spark plug leadsbeing replacedr:;] 3If the charge coil or ignition module is being replaced,
'" 1To avoid accidental starting of engine while servicing,
Icl 2Remove the screws retaining the ignition component that is
separate the bullet connectors underneath the ignition module
Remove the wire clamp from the ignition plate
Loosen the five ignition plate screwsLift the ignition plate from the powerhead
6Remove the plate from bottom of the ignition plate7Remove the leads from the spiral wrap and from the ignition component
8Apply OMC Ultra Lock to the threads of the component
retaining screwsLoosely install the new ignition component on the ignition plateConnect bullet connectors if necessary
f811gl 9
Route leads and install clamp