1990 Johnson Evinrude "ES" 9.9 thru 30 Service Manual, P/N 507871, Page 72Get this manual
Manual Primer If the primer is difficult to operate or suspected of not working: 1Remove primer hose from nipple in carburetor Install hose end into suitable container to catch fuel2Squeeze fuel tank primer bulb to fill carburetor bowls with fuel3Operate primer pump twice Fuel should squirt from the hoses into the container, indicating primer is functioning4Inspect primer nipple to ensure nipple is free of obstructions5If primer pump fails to pump fuel from hoses, restricted or kinked hose or inoperative primer pump may be the cause 6Operate primer pump and watch for fuel squirting from hose If fuel squirts from hose, primer pump is okay; if not, proceed to next step f81
7 Remove hose at small nipple on top side of primer pumpInspect hose for kinks or obstructions to flowOperate primer pump; fuel should squirt from small nipple If primer pump fails to pump, inspect inlet hose between primer pump and carburetor for kinks and obstructions If hose is open and not kinked, remove and disassemble primer pump assembly If the primer pump was not working in the above test or is externally leaking, replace the O-rings The three smaller O-rings are made with special material; use only the proper O-rings