1990 Johnson Evinrude "ES" 60 thru 70 Service Manual, P/N 507873, Page 291Get this manual
2Oil and install both trim caps on the trim rods, as shown rJl
3Reinstall the manifold in the holding fixture Oil and install both rim piston and cap assemblies into the manifold Slide the piston into the sleeve, and then with the end cap flush with he manifold, slide the piston all the way to the bottom of the boreDo not thread the end caps into the manifold at this time4Without removing the piston and rod assemblies, slide both end caps off the rods r;;l 5Adjust the manifold on the holding fixture so the trim cylinders are levelUsing the correct fluid, fill both sleeves all the way to the top By filling certain areas of the manifold with fluid during assembly, you will reduce the amount of time necessary to purge the system of air when you are finished
6 Oil and install both trim end caps in the manifold Thread them in flush with the manifold by hand Using OMC Trim Cylinder End Cap Remover PI 324958 and torque wrench, tighten the end caps to torque of 55-60 ftIbs(75-81 Nm)7 Install the two identical short check valves in the front of the manifoldTighten the valves to torque of 50-60 in Ibs(5,5 -7,0 N'm), using drag link socket and torque wrench8 Install the longer trimtilt separation valve