1990 Johnson Evinrude "ES" 60 thru 70 Service Manual, P/N 507873, Page 254Get this manual
WCD1431 7Push core wire CD (from engine end) through wire clamp Q) until wire is flush in (0,8 mm) with end of casing guide r;-;l Turn set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turnThis kinks and locates core wire COB5634
1451 rotate cable forward untilof Grease trunnion pocketLift cable trunnion cap can be Inserted In"to
trunnion pocket of control
1461 Position throttle lever by hand to align rear hex screw with 1471 8The throttle
COB5635
access hole in controlInsert hex wrench through hole and tighten second set screw
lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of housing half until it contacts the stop CD 9Grease trunnion pocket in cover halfPlace casing guide of shift cable between halves of shift lever and shift cable trunnion cap in pocket of housingGrease outside diameter of wire clampInsert clamp through shift lever and casing guide