1990 Johnson Evinrude "ES" 60 thru 70 Service Manual, P/N 507873, Page 252Get this manual
3Lubricate cable ends with OMC Triple-Guard grease fJ1l .tp
i Move throttle lever arm from behind plastic plate to
4Begin cable installation with housing half of control
expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin and drop cable pin through upper lever arm, through eyelet, and into lower lever arm15578
1321 5Grease cable trunnion pocket and insert cable trunnion Ml
into trunniolpocket in housing half
1331 6The throttle lever arm must be in the idle position before
reassemblyMove the throttle lever arm forward toward the front of the housing half until it contacts the stop
1341 7Grease trunnion pocket in cover halfGrease cable pin
and place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin
i of remote controlPosition neutral start switch on