1990 Johnson Evinrude "ES" 60 thru 70 Service Manual, P/N 507873, Page 243Get this manual
Key Switch
1Install the cutoff switch cap and lanyard2Use continuity light or ohmmeter calibrated on high ohms scale to test continuity3Turn the key to the OFF position
Connect meter as shown Meter must show continuity
5Turn the key to the ON position Meter must show no continuity6With meter connected as shown, push key in while in the ON and START positions Meter must show continuity Meter must show no continuity when key is released7Place the control handle in NEUTRAL position8With meter connected as shown, turn key to the START position Meter must show continuity Meter must show no continuity when key is released9Test key switch and wiring if your test results varyU