1990 Johnson Evinrude "ES" 60 thru 70 Service Manual, P/N 507873, Page 229Get this manual
Assembly 1Lubricate the armature shaft bearing surface with one drop of SAE No10 oilLubricate pinion helix on armature shaft with General Electric Versilube OMC PIN 330615 I]J 2
If removed, install retaining ring and washer end of armature shaft
on drive
Assemble drive end capand spacer to drive end of locknutUsing strap wrench to tighten nut to torque of 27-34 ftIbs
pinionanti -drift springarmature shaftInstall new prevent damage to armature, N'm (240-300 inIbs 20-25
4 Assemble armature to frame and magnet assembly, aligning marks on drive cap end and frame 5Install insulated brush and terminal set in commutator end cap with long lead in slotPosition the insulatorsflat washer CD, lockwasher Q), and nut as shown in figure
INote Reversing these brushes will cause motor to run backwardsInstall brush holder CD, brush springs, and ground brushes Screws secure ground brush leads and holder Insert insulated brushes in holder
Assemble commutator end cap to frame and field aligning notch and rib suitable tool for holding brushes in place can be made from putty knife