1990 Johnson Evinrude "ES" 60 thru 70 Service Manual, P/N 507873, Page 220Get this manual
Starter Circuit CheckRemote Control Models Step Procedure Remove black lead from ground Resu lt aIf meter does not read any voltage, proceed to STEP 2bIf meter reads 12 volts (battery voltage) reconnect black lead to ground and proceed to STEP 6
Check voltage between ground and point
ill starter to solenoid cable
from check point
Steps thruRemove
CD Connect voltmeter between point CD
at check point and common groundTurn key switch to start positionVoltmeter should show 12 volts (battery voltage)
prevent starter engagement while making checksCheck voltage between ground and point
Connect meter at
0Turn key
switch to "start" position
aIf meter reads 12 volts (battery voltage), lead is open between
3&In STEPS thru turn key to "off" position before disconnecting and connecting meterTurn key to "start" position after making connection where requiredCheck voltage between ground and point Connect meter at