1990 Johnson Evinrude "ES" 40 thru 55, P/N 507872, Page 133Get this manual
Thermomelt Sti!c Procedure
1Install correct test propeller and place engine in test tank
Twist and remove spark plug leads before changing propellers to avoid accidental starting of engine
2Start engine and run at 3000 RPM for at least five minutes3Reduce the engine speed to 900 RPM and mark the cylinder head with 1250 (52 C) and 1630 (73 C) Thermomelt Stik4At 900 RPM the 1250 (52 C) mark should remain liquid and glossyThe 1630 (73 C) mark should remain dull and chalky If the 1250 (52 C) mark does not become liquid and glossy, troubleshoot the cooling system for causes of overcooling If the 1630 (730 C) mark becomes liquid and glossy, troubleshoot the cooling system for causes of overheating 5When the engine speed is increased to 5000 RPM, both marks should remain dull and chalky If either mark becomes liquid and glossy, troubleshoot the cooling system for causes of overheatingU