1990 Johnson Evinrude "ES" 40 thru 55, P/N 507872, Page 81Get this manual
Installation Recommendations
Carefully follow the installation instructions packaged with the VRO oil reservoirIncorrect installation might restrict the oil supply to the engine and cause serious powerhead damageIf the
VRol system is not used, follow this procedure:
Install protective cap, PIN 315391, over the oil inlet fitting to protect the VRol pumpSecure with clamp PIN 322654 Disconnect the VRol wiring harnessSeal engine harness Amphenol connector with cover, PIN 513366
1Determine if the standard oil reservoir has sufficient capacity for the applicationIf it doesn't, consider 3.0 gallon reservoirRefer to Optional Equipment, this Section2Choose reservoir location that allows easy access and is within installation recommendations The reservoir has 10ft(3 m) of oil hose and 16 ft(4,9 m) of wiring harness3 The reservoir hose can be extended to maximum of 25 ft(7,6 m)If the installation is extended, the oil hose between the primer bulb and engine must be one continuous section with no fittings or connectionsDo not add on to the existing hoseThe wiring harness can be extended by soldering on additional lengths of 16 gauge wireProtect the connections with shrink tube and electrical tapeObserve original wiring polarity