1990 Johnson Evinrude "ES" 40 thru 55, P/N 507872, Page 63Get this manual
Housing and Fuel GaugeCommercial
f21 The fuel level indicator is mounted to the upper housing and
fuel line assemblyThe entire assembly may be removed by removing the four attaching screwsLift the assembly from the tank carefully to avoid damaging the indicator float CD or the screen Cd) at the end of the fuel line
Check for free movement of the indicator on the indicator pin Remove the pin from the indicator support by compressing the free end and pulling it outInspect the indicator to make sure that the float arm is not bent and that the float CD is not damaged or oil-soakedRemove the two screws attaching the indicator support CD to the upper housingLift the indicator lens out of the upper housing, and clean it with solvent or lacquer thinner to remove any foreign matter which may be clouding the lensInspect the lens seal for cracks or shrinkage which may allow leakageWhen reassembling support to housing, tighten screws to torque of 15-20 in Ibs(1,6-2,2 Nm)The release valves must seat tightly to prevent gasoline or fumes from leaking outbut must open clear passage for air to enter the tank and for fuel to be drawn out when the fuel hose is connected Dirt may keep the release valves from seating properlyThe release valves are best cleaned by removing the core plugs and disassemblingReplace valve seats (O-rings) to ensure tight sealInstall small ends of springs on valvesand secure the assembly in the housing using new core plugs staked in placeThe air inlet disc valve must seat tightly to prevent fumes from escaping the tank when the fuel hose is connected, but must allow air to enter the tankThe disc valve spring retainer is staked to the upper housing and may be removed by filing off the burrs if replacement is necessaryRestake with small punch Reassemble upper housing [) to fuel tank using new gasketTighten screws to torque of 25-35 inIbs (2,8-4,0 Nm)0;