1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 393Get this manual
1161-DR2186
1161 8Install locknut on pivot boltReplace the locknut if you do not feel definite resistance to tighteningTorque the locknut to 10-12 ftIbs(14-16 Nm)&
9Install new cotter pin in the bellcrank pivot bolt
f161 10Attach the bellcrank to the spool valveReplace locknut if you do not feel definite resistance to tighteningTorque the locknut to 10-12 ftIbs(14-16 Nm)1181 11Attach the pressure and sump lines to the valve housingRefer to Hose Routing ChartCoat the shoulder bolt with OMC Triple-Guard grease and attach the steering cable to the bellcrankReplace the locknut if you do not feel definite resistance to tighteningTorque the locknut to 10-12 ftIbs(14-16 Nm)1201 13If removed, install the port and starboard lower engine coversInstall the hose support bracket to the starboard cover halfIf removed, secure the steering hoses every in(152 mm) with OMC Tie Straps PIN 91006814Fill the steering reservoir with fresh OMC Power TrimlTiit and Power Steering Fluid or GM Dexronand install the dipstick15Remove the emergency ignition cutoff switch cap and energize the starter in short bursts for 30 seconds1211 16Recheck the reservoir fluid level and fill as necessaryTorque the dipstick to 50-60 inIbs(6-7 Nm)17Recheck the reservoir fluid level after 10 minutes at 800 RPM and several cycles of the steering systemFill as necessaryTorque the dipstick to 50-60 inIbs(6-7 Nm)