1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 331Get this manual

1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 331

Assembly
INote If

removed, apply OMC Locquic Primer and OMC Screw Lock to the brush card screws before installing1Correctly route the brush leads and install the springs and brushesCompress the springs with modified putty

INote Incorrect orientation

?f brushes could damage the starter or cause reverse rotation
2Apply OMC Extreme Pressure grease to the gear housing armature bearing Install the thrust washer and armature
3 Orient the starter framethe long alignment mark will match the mark next to the positive terminal stud on the gear housing

4Push down firmly on the armature and slide the frame into placeAlign the notches in the gear housing and frame
5Apply light coating of OMC Extreme Pressure grease to the end cap bearing and install the end cap

Back to 1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875