1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 327Get this manual

1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 327

Assembly 1Lubricate the armature shaft bearing surface with one drop of SAE No10 oilLubricate pinion helix on armature shaft with General Electric Versilube, OMC PIN 330615 f81 2If removed, install retaining ring and washer
of armature shaft
on drive end

f81 Assemble drive end cappinionanti-drift springand spacer to drive end of armature shaftInstall new locknutUsing strap wrench to prevent damage to armature, tighten nut to torque of 27-34 Nm (240-300 inIbs 20-25 ftIbs
4Assemble armature to frame and magnet assembly, aligning marks on drive cap end and frame
Inl 5Install insulated brush and terminal set in commutator

cap with long lead in slotPosition the insulatorsflat CD, lockwasher Q)and nut as shown in figureINotel Reversing
these brushes will cause motor to run back-

f101 6Install brush holder (0brush springs, and ground brushes

Back to 1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875