1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 89Get this manual

1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875, Page 89

Warning Signals Avoid pulling "E.S1763" fuel line off fuel fittingsPush off wherever possibleWhen removing "E.S1763" fuel line from fittings, carefully cut the hose to avoid damaging the fittings"Low" Oil Signal complete procedure for testing the "low oil" circuit can Installation Recommendations, this Sectionbe found in "No Oil" Signal 1Connect shop tank with 50:1 fueloil mixture to the fuel inlet fitting2Remove the oil supply hose from the avoid damaging the fittingoil inlet fitting to

3Start the engine and run at 1000 RPM in gear4After the residual oil is exhausted from the oil pump, the "no oil" circuit should activate the control box warning horn5The signal should be approximately off12

second on,

Back to 1990 Johnson Evinrude 120 thru 140, 185 thru 225, 300 HP, P/N 507875