1989 Johnson Evinrude "CE" Colt/Junior thru 8 Service Manual, P/N 507753, Page 255Get this manual
[!QJ 3[fIJ 4[]]J 5 Position spring retainer
CD on pulley as shown
Lubricate spring with OMC Triple-Guard grease or Lubriplate 777Hook end loop of spring to pulley roll pinInstall cup and stop assembly with washer over pulleyBe sure spring is positioned through tabs as shown
6Temporarily insert shoulder screw through cup and stop assemblyInstall nut on the shoulder screw to secure assembly
7While pressing down on pulley, turn pulley clockwise and wind spring into cup and stop assembly until outside loop of spring engages outside face of assembly8Slowly release pulley, relieving spring tension Hold starter assembly together and remove shoulder screws
COA1178
[]] 9Position idler gear arm spring idler gear on idler gear arm
in idler gear arm Place
10Clean threads of shoulder screw to remove adhesiveSpray threads with OMC Locquic PrimerCOA1179
Insert shoulder screw through idler gear armInstall idler gear arm assembly over pulleyBe sure stop of idler gear arm is positioned between the two tabs CD of the cup and stop assemblyInstallation