1989 Johnson Evinrude "CE" Colt/Junior thru 8 Service Manual, P/N 507753, Page 186Get this manual
Assembly Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or
Evinrude Outboard LubricantINotel Use new gaskets, seals, and O-rings during assembly1If removed, install wrist pin bearing using OMC Bearing Installer and Remover PIN 327645
f11l1 1When installing wrist pin bearing the oil hole must Note
line up with the hole in rod end
1121 f13l 2
Using OMC Cone PIN 333142 and Driver PIN 333141, install one snap ring in groove of pistonWhen installed, gap of the ring should be positioned opposite groove in the piston"" To avoid personal injury, use insulated gloves when handling pistons that have been heated3Heat the piston to 200F- 400F(93C- 204CUsing OMC Piston Cradle PIN 326573 and OMC Pressing Pin PIN 333141oil and start the wrist pin into the piston opposite the installed retaining ringDo not allow the wrist pin to enter the piston cavity114