1989 Johnson Evinrude "CE" 9.9 thru 30 Service Manual, P/N 507754, Page 333Get this manual
Shift Cable20 thru 30 1Place engine shift lever in "Neutralposition (Propeller shaft will turn freely when in "Neutral" position 2Check that remote control handle is in "Neutralposition and the fast idle lever in "Run" (latched) position3Place shift cable through anchor bracketlever armInstall the flat washer and locking nut supplied with engineDo not substitute locknutTighten locknut securely5Adjust the length of the shift cable by turning the knurled adjusting nut on the shift cable until the cable trunnion fits into the trunnion anchor pocket in trunnion anchor block ill
J: 4Install shift cable casing guide on shoulder bolt of shift
r:jl J: 6Secure shift cable in anchor bracket by installing screw
and locknutTighten screw securely
Throttle Cable20 thru 30