1989 Johnson Evinrude "CE" 9.9 thru 30 Service Manual, P/N 507754, Page 331Get this manual
Installation of Cables on Engine To prevent accidental starting of engine, always remove ignition key from start switch and remove cap from emergency ignition cutoff switch if boat is so equipped Disconnect battery cables at battery
1Identify the throttle cable from the shift cable at the engine end of cables by shifting control handle into "Forward The shift cable will move first2Lubricate the shift and throttle cable ends with OMC Tripe Guard greaseShift Cable9.9, 15 1Place engine shift lever in "Neutral" position (Propeller shaft will turn freely when in "Neutral" position 2Check that remote control handle is in "Neutral" position and the fast idle lever in "Run" (latched) position6498
lJplacing connector pin through shifting connector and