1989 Johnson Evinrude "CE" 9.9 thru 30 Service Manual, P/N 507754, Page 323Get this manual
Q)CD 1431
Push core wire CD (from engine end) through wire clamp
Q) until wire is flush in(0,8 mm) with end of casing
set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turn This kinks and locates core wire
1441 Turn
1451 Grease trunnion pocket of controlLift throttle cable and 1461 Position throttle lever by hand to align rear hex screw with
rotate cable forward until trunnion cap can be inserted into trunnion pocket of controlaccess hole in controlInsert hex wrench through hole and tighten second set screw
8The throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of housing half until it contacts the stop CD Grease trunnion pocket in cover halfPlace casing guide of shift cable between halves of shift lever and shift cable trunnion cap in pocket of housing Grease outside diameter of wire clamp Insert clamp through shift lever and casing guide