1989 Johnson Evinrude "CE" 9.9 thru 30 Service Manual, P/N 507754, Page 322Get this manual
OMC Long Life CablesInstallation OMC Cable Adapter Kit, PIN 173600, must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control and pull two halves apart
and cover half on flat surfaceApply OMC Triple -Guard grease to all points shown in figuresBe sure to grease the three cover screw threaded holesQ
r:;:;J 2Place housing half
COB5630
1381 1391
3Lu bricate outside of brass sleeves at control end of both remote control cables with OMC Triple-Guard grease4Place trunnion caps over cable trunnion and slide casing guides over cable sleeves5Using in hex wrench, start the set screws into each end of both control end wire clamps
14111421
6Begin cable installations with housing half of controlMake certain fast idle lever is completely down Move throttle lever arm from behind separator plate to expose hole in lever armIt is not necessary to remove separator plate to install control cablePlace casing guide between halves of throttle lever arm and position guide as shownGrease outside diameter of wire clamp and insert clamp through throttle lever arm and cable casing guide