1989 Johnson Evinrude "CE" 9.9 thru 30 Service Manual, P/N 507754, Page 234Get this manual
Assembly 25 1Using OMC Bearing Installer PI 319876, oil and install the large bearing in the propeller shaft bearing housing Press against the lettered side of the bearing when installing 1261
2Using OMC Bearing Installer PI 319875, oil and install the small bearing in the propeller shaft bearing housingPress against the lettered side of the bearing when installing9602
r::;:;] 3Install two new seals back to back using OMC Seal Installer PIN 334999Install the outer seal onto the tool with lip facing the toolInstall the inner seal onto the tool with lip facing away from the toolApply OMC Gasket Sealing Compound to the metal casing of the sealsInstall the seals into the housing until the seals are seated Apply OMC Triple-Guard grease to the seal lips after installing
4Apply OMC Triple-Guard grease to new bearing housing 0ring Place the O-ring in the bearing housing groove28 5To install the forward bearing cup into the gearcase, remove the gearcase from the holding fixture and place the nose of it on wooden blockDrive the bearing cup in with mallet and OMC Bearing Cup Installer PI 319929 attached to OMC Drive Handle PI 311880