1989 Johnson Evinrude "CE" 9.9 thru 30 Service Manual, P/N 507754, Page 117Get this manual
Ignition Component Replacement twist and remove all spark plug leads"" 1To avoid accidental starting of engine while servicing, 2Remove the screws retaining the ignition component that is being replaced f6l
3If the charge coil or ignition module is being replaced,
separate the bullet connectors underneath the ignition module
4Remove the wire clamp from the ignition plate
L!J from the powerhead
5Loosen the five ignition plate screwsLift the ignition plate
Remove the plate from bottom of the ignition plate
7Remove the leads from the spiral wrap and from the ignition component
8Apply OMC Ultra Lock to the threads of the component
retaining screwsLoosely install the new ignition component on the ignition plateConnect bullet connectors if necessary