1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 361Get this manual
Shift Cable20 thru 30 1Place engine shift lever inNeutral" position(Propeller shaft will turn freely when in "Neutral" position 2Check that remote control handle is inNeutral" position and the fast idle lever in "Run" (latched) position 3Place shift cable through anchor bracketlever arm Install the flat washer and locking nut supplied with engineDo not substitute locknutTighten locknut securely5Adjust the length of the shift cable by turn ing the knurled adjusting nut on the shift cable until the cable trunnion fits into the trunnion anchor pocket in trunnion anchor block ill
J':4Install shift cable casing guide on shoulder bolt of shift
6Secure shift cable in anchor bracket by installing screw and locknutTighten screw securely
Throttle Cable20 thru 30 1Place throttle cable trunnion into idle bracket]f4l
2 Attach spring clip to guide by sliding onto side of guide and turning until holes in spring clip snap over both pins on guide 3Attach casing guide to engine throttle arm and secure