1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 351Get this manual
1431 7 Push core wire CD (from engine end) through wire clamp Q) until wire is flush 1132 in(0,8 mm) with end of casing guide Turn set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turnThis kinks and locates core wire Grease trunnion pocket of controlLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocket of controlC085635
Position throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screw8The throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of housing half until it contacts the stop CD