1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 349Get this manual
3Lubricate cable ends with OMC Triple-Guard grease IJ1l 1f
4Begin cable installation with housing half of controlMove throttle lever arm from behind plastic plate to expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin CD and drop cable pin through upper lever arm, through eyelet, and into lower lever arm
13215Grease cable trunnion pocket and insert cable trunnion
into trunniolpocket in housing half
13316The throttle lever arm must be in the idle position before
reassembly Move the throttle lever arm forward toward the front of the housing half until it contacts the stop
13417Grease trunnion pocket in cover halfGrease cable pin
and place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin
8Shift lever arm must be in neutral before reassembly of remote controlPosition neutral start switch on center of neutral start cam while making sure neutral lock slide of control handle is engaged in notchControl handle should not be able to move without releasing neutral lock slideIf the neutral lock slide does not engage notch in index plate when neutral switch is centered on neutral cam, it will be necessary to reposition either the control handle or the index plate