1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 342Get this manual
Control Cable Identification
1Install the throttle and shift cables in the remote controlRefer to Cable Installation, Page 9-162Put the control handle in NEUTRAL position
Inl 3When the control handle is in NEUTRAL position, the
throttle cable casing guide will be completely retracted and the shift cable casing guide will be at the midpoint of its travel1::=:::JmI ,jj ,I_,ji
Inl 4As you move the control handle through FORWARD, the
shift cable casing guide must retract and the throttle cable casing guide must begin to extend5As you move the control handle through REVERSE, both casing guides must extend6Identify each control cable for proper installation later
D;R2::,O:.67J
ill before continuing with installationControl Handle Friction
Control cable identification and function must be correct
11 ()I-5973
1The throttle friction knob adjustment must be just tight enough to eliminate unwanted throttle "creep" under normal operating conditionsr:j()l 2The knob is turned clockwise to increase the friction and counterclockwise to decrease the friction 3Make light preliminary adjustment before operating the engine4Make your final adjustment with the boat and engine operating under normal conditionsTrimTilt Switch 1Temporarily disconnect the control handle trim tilt harness from the trimtilt motor harness2Use continuity light or ohmmeter calibrated on high ohms scale to test continuityf11l 3: directionmeter as shownPress the switch in the UP