1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 288Get this manual
'oGmImItim t1:n:I:!I ;zza
1291 Position diameter pinion thrust washer with side facing the small the inside chamfered on the pinionchamfered
pinionOil and install the thrust bearing Install the large thrust washer with chamfered outside edge facing up9Install pinion in gearcase
1301 10Grease the end of shift rod and slide it through the shift rod bushing Place the cradle on the shifter lever r:;:;l r:;:;] 11Place the spring and two detent balls in the hole in the propeller shaftWhile holding the detent balls and spring in the hole, slide the clutch dog onto the propeller shaft splines with the chamfered and grooved lugs toward the forward gear and aligned as shown 83298