1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 287Get this manual
COA3432
Assembly 1Coat the shift rod -ring with OMC Triple -Guard grease and install in shift rod bushing
Apply OMC Gasket Sealing Compound to the outside diameter of the bushingInstall the bushing and washer using OMC Shift Rod Bushing Installer, PI 304515
1241 3Oil, then
install new upper driveshaft bearing in the gearcase using OMC Upper Driveshaft Bearing Installer, PI 326564Press the bearing into the gearcase against the lettered side of the bearing and until the tool is seated on the gearcase
251 Install two new upper drives haft seals back to back in the
gearcase using OMC Upper Driveshaft Seal Installer, PIN 330655, attached to OMC Drive Handle, PIN 378737 Apply OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing toward the gearcase and the outer seal with lip facing away from the gearcase Apply OMC Triple-Guard grease to the seal lips after installing