1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 263Get this manual
1301 Using OMC Bearing Installer PI 319931 and an arbor press, install the driveshaft bearing into the bearing sleeve with the lettered side against the tool8Using OMC Bearing Installer PI 319931, oil and install the bearing sleeve with the bearing into the gearcase with the lettered side of the bearing against the tool132133 9Using OMC Seal Installer PI 326554, install two new driveshaft seals back to back as followsApply OMC Gasket Sealing Compound to the metal casing of the seals before installing Install the inner seal Q) with lip of the seal faCing toward the gearcaseInstall the outer seal with lip of the seal facing away from the gearcase Apply OMC Triple-Guard grease to the seal lips after installing 10Coat the shift rod O-ring with OMC Triple -Guard grease and install in shift rod bushing 134 11Place new washer CD and bushing on OMC Shift Rod Bushing Installer PI 304515Apply OMC Gasket Sealing Compound to the outside diameter of the shift rod bushing Using mallet, drive the bushing into the gearcase 12Oil a.nd place the forward bearing cone and roller assembly in the forward bearing cup 35 13To install the forwa rd gear and the shifter lever and yoke assembly, begin by threading OMC Yoke Locator PI 319991 through the shift rod bushing and threading it into the shifter yoke Then while pulling on the yoke locator, guide he assembly into the gearcaseThe forward gear should come to rest against the forward bearing, and the shift lever should be located in the slot at the bottom of the gearcase