1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 196Get this manual
Inspection 1Before any inspection process can begin, all internal cOIT!Ponents must be clean and free of excess oilRefer to Cleanmg, this section 2Make visual inspection of all internal components Check for unusual wear patterns, scuffing or deterioration of aluminum parts, heat-related discoloration of bearings or bearing surfaces, and broken components
Check for cylinder head warpage using piece of bar stock or machinist's straightedge and feeler gauge set Cylinder head warpage must not exeed .004 in (0,10 mm) end to endResurface or replace head if warpage exceeds this dimension
4 Use micrometer to measure the diameter of each crankpin and main bearing journalThe lower main bearing journal would only be measured if the bearing was removed for another reasonRefer to Engine Specif ications, Section 1, for dimensions
1391 514016
Use telescoping gauge or inside reading micrometer to inspect each cylinder bore for an out-of-round, oversize, or tapered condition Be sure the gauge or micrometer is perfectly square in the bore when measuring