1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 193Get this manual
12Using tool as drawn on page 4-9, or equivalent, push the taper pin toward the intake manifold surfaceDo not use any tool smaller than the taper pin bore to remove the pin
13Remove the six main bearing screws and eight flange screws
14Turn the powerhead with the intake facing up and then tap lightly upward on the crankshaft until the crankcase halves begin to separate
15Lift the crankcase from the cylinder block
12sl Note
rods, rod and retainers are wearing parts and seat With the operation of the engineBecause of this, it is essential to maintain their original positions at reassemblyUsing an indelible ink marker, mark each connecting rod, cap, and bearing component when they are removed to ensure correct mating, and keep the needles of each cylinder togetherout