1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 190Get this manual
11Remove the fuel pump inlet hose12Disconnect the overboard water indicator hose from fitting on exhaust cover13Remove hoses from manual primer 171
14Remove the stop button lead from "Eterminal of the five wire connectorRemove its ground lead from the ignition coil screw15Remove the pin
E.I Q) Disengage the link from the shift actuator cam 16Remove the ground lead from the powerhead
and washer from the actuator cam link
17Using OMC Special Y2 inBox Wrench PIN 322700, remove port and starboard powerhead retaining nuts with washers18Remove the four screws retaining the powerhead to the exhaust housing
r:;-:;-l 19The powerhead now can be removedAssemble the following componentsPuller Body PI 307636, three Screws PI 307641, and three Washers PI 307639Thread OMC Lifting Eye PI 321537 into the body and engage aper of the crankshaftThen, tighten the lifting eye securelyUsing hoist, lift the powerhead from the exhaust housing It may be necessary to rock the powerhead sideways to break the gasket loose