1988 Johnson Evinrude "CC" 9.9 thru 30 Service Manual, P/N 507660, Page 135Get this manual
Ignition Com pon ent Replacement All Models Ignition Coil Removal Twist and remove cover to remove the high tension lead and primary leads from the ignition coilsI
2Notice the fastener and washer orientation before removing any screws3Remove the coil mounting screws and remove the coil and ashersIgnition Coil Installation 1Assemble the correct sequence of washers and locate the ignition coil on the powerheadInstall and tighten the retaining screws to torque of 48-96 inIbs(5,4-10,8 Nm) 2Apply light coating of OMC Triple-Guard grease to the ribbed portion of the spark plug ceramics and to the openings of each of the high tension lead coversInstall the high tension leads3 Applya light coating of OMC Triple -Guard grease to the opening of each primary lead cover and install the covers Observe proper wire routing and ignition timing: connect orangeblue lead to top ignition coil and orange lead to bottom ignition coil