1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 343Get this manual

1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 343

Trim Sending Unit Adjustment It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full trim-up positionTo do this, proceed as follows: 1Turn ignition key to the ON position2Raise the engine with the tilt switch to maximum trim-up position
1321 313314
Move the angle adjusting rod

to the center hole
until only snug, so

Loosen the sending unit screws the sending unit can be pivoted

Back to 1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual