1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 338Get this manual
2Oil and install both trim caps on the trim rods, as shown 3Reinstall the manifold in the holding fixture Oil and install both trim piston and cap assemblies into the manifoldSlide the piston into the sleeve, and then with the end cap flush with the manifold, slide the piston all the way to the bottom of the boreDo not thread the end caps into the manifold at this time f31
4Without removing the piston and rod assemblies, slide both end caps off the rods
5Adjust the manifold on the holding fixture so the trim cylinders are levelUsing the correct fluid, fill both sleeves all the way to the topBy filling certain areas of the manifold with fluid during assembly, you will reduce the amount of time necessary to purge the system of air when you are finished
6Oil and install both trim end caps in the manifoldThread
EJ them in flush with the manifold by hand Using OMC Trim