1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 327Get this manual
Power TrimTilt Servicing Removal 1Mark angle adjusting rod location and remove rod 2Lift engine manually and engage tilttrail lock3Remove blue and green wires from pump motor connector housing
4Remove spring clip from tilt cylinder pin5Remove tilt cylinder pin with punch and mallet6Manually retract tilt cylinderRemove three screws, port and starboard, holding the unit to the stern brackets7 Remove trimtilt unit, as shown, and pull control cable through stern bracket
Disassembly Thoroughly clean unit before disassemblingScrub all outside surfaces with stiff bristle brush and hot soapy waterThis will prevent dirt particles or other foreign matter from entering the unit while you are working on itMount the unit on OMC Power Trim and Tilt Test Stand, PIN 390008Place the unit and stand in shallow tray to catch the hydraulic oil as it drains from the unitNeutralize the internal pressures of the power trimtilt unit before disassemblingUsing battery, operate the unit until the trim and tilt cvlinders are completely downReverse the connections on the battery and momentarily operate the unitThere may be high pressure behind some check valves and in hydraulic linesTo prevent possible eye injury, when removing lines and check valves, be sure to keep clean, "lint free" shop cloth covering them until the pressure is releasedUse eye protection