1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 301Get this manual
t 1431 _K
guide G-;l Turn set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turnThis kinks and locates core wire
14317Push wire is flush (from engine end) through wire casing core wire Q) clamp Q) until in(0,8 mm) with end of
1451 rotate cable forward untilof control.cap can be inserted into Grease trunnion pocket Lift throttle cable and trunnion
trunnion pocket of controlCOB5635
Position throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screw