1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 299Get this manual
3Lubricate cable ends with OMC Triple-Guard grease f311 '"
ill Move throttle lever arm from behind plastic plate to
4Begin cable installation with housing half of control
expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin and drop cable pin through upper lever arm, through eyelet, and into lower lever arm13215Grease cable trunnion pocket and insert cable trunnioninto trunniolpocket in housing half13316The throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of the housing half until it contacts the stop
7Grease trunnion pocket in cover halfGrease cable pin and place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin 34 1
ill of remote controlPosition neutral start switch on