1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 259Get this manual
8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the pulley with the inner loop of the rewind spring and install the pulley in the starter housing9Place the friction plate spring washer and the friction plate on the pulley hubSecure the friction plate and friction plate spring washer with the pulley lockring 10Be sure the starter pawl bushing is installed in the pulleyApply OMC Triple-Guard Grease or Lubriplate 777 to boss of the starter pawlPlace spring washer on the boss of the starter pawlPlace the starter pawl in the pulley11Position the starter housing spring
in the starter housing
12Install the starter pawl plate return spring on the starter pawl plate CD Press the other end of spring on the boss of the pulleyPosition the starter pawl plate on the pulley13Clean threads of the starter pawl plate retaining screw and nut to remove adhesiveInstall the starter pawl plate retaining screw Q) and washer into the starter housingTighten screw to torque of 14-16 Nm (10-12 ftIbsSpray threads of starter pawl plate retaining screw that protrude through the starter housing and threads of the nut with OMC Locquic PrimerApply OMC Screw Lock to the threads of the nutInstall and tighten the nut securely14Using the shoulder screw, install the rope guide to the starter housingTighten the shoulder screw securely15If removed, install the starter handle bracket to the starter housingBe sure to place the washers between the rubber mounts of the starter handle bracket and the starter housingTighten the shoulder screws securely