1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 227Get this manual
130 IfJ1l Oil, OMC install newInstaller PIN the bearing housing then bearings in using Bearing 326562 Press
against the lettered side of the bearing to prevent damage to the bearings when installing
132133 housing usingseals back to back in the rear of the bearing 7Install new OMC Propeller Shaft Bearing Housing Seal
Installer PIN 326551Apply OMC Gasket Sealing Compound to the metal casing of the seals before installing Install the inner seal with lip facing toward the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing,COA3559
1348LightlyO-ringInstall Triple-Guardingrease toof the housing apply OMC new bearing the O-ring groove housing
Install new O-rings on the retaining screwsDriveshaft Bearing Housing Servicing
1Note Ilf the needle bearing in the housing is worn, the bearing and the housing must be replaced as an assembly1 1Remove_ the two bearing housing seals using OMC 35 Bearing arid Seal Remover PI 391259Discard the seals1 2Remove and discard the O-ring from the bearing housing 36