1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 226Get this manual
Propeller Shaft Bearing Housing Service Inspect the bearings in placeIf bearing is removed for any reason it must be replaced 12711 To remove the two seals,
use either OMC Bearing and Seal Remover PIN 391259 or OMC Narrow Two-Jaw Puller PI 391010 attached to OMC Slide Hammer PIN 391008
12sl'2To remove the frontOMC Slideattach OMC Wide Two-Jaw bearing, Puller PIN 391012 to Hammer PIN 3910101291 3To removethe rear bearing, attachOMC Narrow Two-Jaw Puller PI 391010 to OMC Slide Hammer PIN 3910084Thoroughly clean the bearing housing and the four bearing housing retaining screws in solventDiscard the retaining screws' O-rings5Inspect the bearing housing anodeReplace anode if it has beenreduced to two-thirds its original size (one-third eroded)