1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 170Get this manual
Assembly JNoteJ Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard LubricantINotel Use new gaskets, oil retainers, and O-rings during assembly 1461
1Using OMC Cone and Driver PIN 318600 and PIN 318599, install one new wrist pin retainer in the bottom of
should be positioned
each piston, opposite the word "UP" on the piston dome
14711 Note 1When installed, the ring gap
opposite the piston groove
2 60, 75 modelsoil the wrist pin and wrist pin bore and loosely install wrist pin in "L" side of pistonSlide one washer into place, flat side down